Ignition ON
Note:
These TECH 1 parameters give a reference on the
positions in which the control unit detects the maximum current.
If the TECH 1 parameter S.
ROOF MOTOR SP. is less than the minimum value for the motor speed and
the TECH 1 parameter MOTOR CURRENT is
greater than the maximum value for the current consumption, the electric
sliding roof is defective / dirty.
In this, the TECH 1 parameters JAMMED POS. 0 to JAMMED
POS. - 7 provide the temporal sequence of the detected actual
values.
JAMMED POS. 0 always
shows the last detected actual value and JAMMED
POS. - 1 to JAMMED POS. -7
represent each actual value measured before that.
If the actual values from JAMMED POS. 0 to JAMMED POS. - 7 are almost at the
same place, a mechanical defect must be looked for at this position.
|