Fasten dial gauge bracket of MKM-572 (1) to brake cover plate.
Set probe (2) of dial gauge on front side of wheel hub and measure
lateral runout.
Permissible radial runout: max. 0.05 mm.
If there is a deviation from the nominal value; replace wheel
hub – see operation "Wheel Hub and/or Rear Wheel Bearing,
Remove and Install or Replace".
Install
Brake disc to front wheel hub – tightening torque 4 Nm / 3
lbf. ft.
|
Install brake calliper on semi-trailing arm – tightening
torque 80 Nm / 59 lbf. ft.
|
Mount rear wheel – tightening torque 110 Nm / 81 lbf.
ft.
|
|