|
Note: On the front
axle, the wheel sensor pulse generating wheels can only be replaced
complete with the front wheel hub. Replace front wheel hub –
see operation "Wheel Bearing / Wheel Hub, Replace" in group "E".
Replacement of the wheel sensor pulse generating wheels on the rear
axle is described below.
 Remove
Remove drive shaft – see operation "Drive Shaft, Remove
and Install or Replace" in group "F". Clamp drive shaft in vice
with protective jaws. Drive off the wheel sensor pulse pickup from
the transmission-side drive shaft joint using a suitable drift.
Install
Position the wheel sensor pulse pickup on the transmission-side
drive shaft joint. Using a suitable drift, drive the pulse pickup
with blows distributed around the circumference until a gap (I) of
8 mm from the drive shaft joint is achieved.
Install drive shaft – see operation "Drive Shaft, Remove
and Install or Replace" in group "F".
|
