|
Note: Before
installing torsional vibration damper hub, check that disc spring
(4) is in perfect condition.
Install
Align torsional vibration damper (1) gap (2) and disc spring
(4). Shoulder (3) of torsional vibration damper hub should point
away from timing case.
Attach Counterhold KM-819 to torsional vibration damper hub
using attachment screws from torsional vibration damper and support
on suitable bearing surface (use pipe extension if necessary).
Install torsional damper hub with new fastening bolt at
crankshaft – tightening torque – 100 Nm / 74 lbf. ft. +
90° + 60°.
Install torsional vibration damper – see operation
"Torsional Vibration Damper, Remove and Install".
|
