Vauxhall Workshop Service and Repair Manuals

Oil Injection Nozzle (Piston Cooling), Remove and Install

  Remove

Remove oil pan – see operation "Oil Pan, Remove and Install". Remove oil intake pipe (3 attachment screws). Remove attachment screws (1) and (2) from bearing bridge. Remove bearing bridge. Remove oil spray nozzles (3) (2 fastening bolts).   Clean Clean all sealing surfaces.   Inspect If the oil injection nozzle is re-used, check it for permeability and damage.

  Install

Attach oil injection nozzle to cylinder block – tightening torque 8.5 Nm / 6.3 lbf. ft.

Attach bearing bridge to cylinder block – tightening torque 23 Nm / 17 lbf. ft.

Attach oil intake pipe and new oil seal (seal bead pointing to oil intake pipe) to oil pump – tightening torque 11 Nm / 8 lbf. ft.

Install oil pan – see operation "Oil Pan, Remove and Install".