|
Cylinder Head Cover, Remove and Install
 Remove
For Y 22 XE and Z 22 XE: Remove ignition module – see
operation "Ignition Module, Remove and Install (Y 22 XE, Z 22
XE)".
For X 20 XEV: Detach ignition cable cover from cylinder head
cover.
Remove crankcase ventilation hoses (x 3) from cylinder head
cover.
Detach wiring harness plug from camshaft sensor.
For X 20 XEV: Detach spark plug connectors from spark plugs with
MKM-836 and remove ignition cables from bracket.
Remove cylinder head cover from cylinder head – note seal
rings.
 Clean
Clean sealing surfaces and remove gasket remnants.
Install
|
Apply sealing compound (black) to sealing surfaces (arrows).
Attach cylinder head cover with new seal rings (1) and new
gaskets (2) to cylinder head – tightening torque 8 Nm / 6
lbf. ft.
For X 20 XEV: Connect spark plug connectors to spark plugs
– note cable routing.
Attach wiring harness plug to camshaft sensor.
Attach crankcase ventilation hoses (x 3) to cylinder head
cover.
For X 20 XEV: Attach ignition cable cover to cylinder head cover
– tightening torque 3 Nm / 2 lbf. ft.
For Y 22 XE and Z 22 XE: Install ignition module – see
operation "Ignition Module, Remove and Install (Y 22 XE, Z 22
XE)".
|
|
|
