Remove injection lines – see operation "Injection Lines,
Remove and Install".
Disconnect injection nozzle needle movement sensor (2)
cable.
Disconnect oil leakage lines (1) from injection nozzle
holder.
Remove injection nozzle holder from cylinder head with KM-133-C
(3).
Install
Connect injection nozzle holder and new seal to cylinder head
with KM-133-C – tightening torque 60 Nm / 44 lbf. ft.
Connect leakage oil lines to injection nozzle holder.
Attach injection nozzle needle movement sensor cable.
Install injection lines – see operation "Injection Lines,
Remove and Install".
|