|
Camshaft and Cam Follower, Remove and Install
(Cylinder Head Removed)
 Remove
|
Detach cover of thrust plate from camshaft housing. Remove
thrust plate (1) from camshaft housing. Remove camshaft from
camshaft housing. Edge front seal ring out of camshaft housing.
 Clean
Clean sealing surfaces and remove gasket remnants.
Inspect
Check camshaft housing for damage and wear – see operation
"Camshaft Housing, Check for Evenness".
When replacing camshaft, all cam followers must be replaced.
|
|
Install
Coat sliding surfaces of the camshaft with MoS 2 lubricating paste (grey), insert camshaft in camshaft
housing. Attach pressure plate to camshaft housing –
tightening torque 8 Nm / 6 lbf. ft.
Lightly coat sealing lip of front seal ring with silicon grease
(white). Install new front seal ring with KM-422 in camshaft
housing – use bolt and washer of camshaft pulley.
Attach thrust plate cover with new gasket to camshaft housing
– tightening torque 8 Nm / 6 lbf. ft.
Attach camshaft housing to cylinder head – see operation
"Cylinder Head, Remove and Install".
|
