Measure height of roller bushing to be installed.
Install two-part Adjustment Tool KM-713 to roller bushing and
tighten by hand. Bead of roller bushing (arrow) points to the thumb
screw of the tool. Tighten the thumb screw until the end play of
the rollers is corrected.
Measure and record dimension "1" from outer edge of Measuring
Plate KM-713-1 to outer edge of roller bushing (without bead) in a
straight line.
Determine thickness of shims required according to following
calculation sample. The axial play should be 0.15 to 0.25 mm.
Shims available: 1.7 mm, 1.8 mm, 2.0 mm, 2.1 mm, 2.2 mm.
|