Activated Carbon Canister, Remove and Install
Note: The activated
carbon canister is located in the front right wheel housing.
Remove
Remove right front wheel.
Remove inner wing protective panelling – see operation
"Protective Panelling – Inner Wing, Remove and Install" in
group "A".
Remove fastening nut and pull activated carbon canister upwards
out of bracket.
Remove hoses from activated carbon canister.
Install
Connect hoses to activated carbon canister.
|
1 =
|
Vent line connection from fuel tank – Ø 8 mm.
|
2 =
|
Purge line connection to tank vent valve – Ø 6 mm,
do not fasten with hose clamp (risk of destruction)!
|
3 =
|
Route vent line downwards between activated carbon canister and
wheel housing – Ø 10 mm.
|
|
Fasten vent line to activated carbon canister with cable ties
(4).
|
|
|
Insert activated carbon canister in bracket and tighten
fastening nut – tightening torque – 4 Nm / 3 lbf.
ft.
Install inner wing protective panelling – see operation
"Protective Panelling – Inner Wing, Remove and Install" in
group "A".
Attach right front wheel – tightening torque 110 Nm / 81
lbf. ft.
|