No.
|
TECH 1 Display
|
Conditions for Checking
|
Nominal Value
|
Trouble Codes
|
Terminal
|
03 |
TURN SIG. RELAY
|
Ignition
ON
Press
key F5 in the system main menu.
Follow
the instructions in TECH 1
Start
actuator test
Note:
The
turn signal lamps are actuated at a frequency of 0.5 Hz
(switch-on
time 1 s).
The
check is completed after a maximum of 30 s.
|
alternately
INACTIVE
and
ACTIVE
LEFT
and RIGHT turn signal units flash simultaneously
|
|
24, 25
|
Notes
on Trouble-shooting: |
Nominal
Value:
|
Cause
of Fault:
(If
nominal value is not attained)
|
· Release and disconnect wiring harness plug
from anti-theft warning system control unit K94 |
|
|
· Connect wiring harness plug K94/Ter. 24 in
instrument panel wiring harness |
Constant
illumination of: front left turn signal lamp and rear left turn signal lamp
|
· Instrument panel wiring harness, interruption
from: K94/Ter. 24
to: S52/Ter. 9
· Trouble-shooting of vehicle electronics in area of turn signal
lamps H11, H12, H13, H14 and wiring harness plug for instrument panel/body X1
|
· Connect wiring harness plug K94/Ter. 25 in
instrument panel wiring harness to ground |
Constant
illumination of: front right turn signal lamp and rear right turn signal lamp
|
· Instrument panel wiring harness, interruption
from: K94/Ter. 25
to: S52/Ter. 11
· Trouble-shooting of vehicle electronics in area of turn signal
lamps H11, H12, H13, H14 and wiring harness plug for instrument panel/body X1
|
If nominal values are attained: |
|
· Control unit K94 defective
|
|
|
|
|
|
|
|