No.
|
TECH 1 Display
|
Conditions for
Checking
|
Nominal Value
|
Trouble Codes
|
Terminal
|
15
|
BRAKE LIGHT
|
Ignition ON
|
OKAY 12V
|
-
|
16/2
|
|
FUSE
|
|
|
|
26-pin
|
|
|
|
|
|
|
Notes for Trouble-shooting:
|
Nominal Value:
|
Cause of Fault:
(If nominal value is not attained)
|
· Ignition OFF
|
|
|
· Check fuse F2:
|
OK
|
· Replace fuse F2
|
|
|
|
· Ignition ON
|
|
|
· Brake pedal not actuated
|
|
|
· Check fuse F2:
|
OK
|
· Lead from F2 to 26-pin MID wiring
harness plug Ter. 16, brake lamps switch S8 and hazard warning lamps switch
S52 has short circuit to ground
|
|
|
· Lead from S52 to turn signal K10 has
short circuit to ground
|
|
|
· Turn signal K10 defective
|
|
|
· Hazard warning lamps switch S52
defective
|
|
|
· MID defective
|
|
|
|
· Actuate brake pedal, then check fuse
F2:
|
OK
|
· Lead from brake lamp switch S8 to bulb
control P25/Ter. 12 or P39/Ter. 54A or Ter. 54E has short circuit to ground
|
|
|
· Lead from S8 to brake lamps H9, H10,
H36 or to trailer socket XA/Ter. 6 has short circuit to ground
|
|
|
· Lead from S8 to cruise control K14/Ter.
G or to AT control unit K85/Ter. 39 has short circuit to ground
|
|
|
· Lead from S8 to turbodiesel control
unit K70/Ter. 26 or to ABS control unit U4.8/Ter. 2 (25-pin plug) has
short circuit to ground
|
|
|
· Lead from S8 to brake and brake lockout
control unit (Japan version) K102/Ter. 3 has short circuit to ground
|
|
|
|
|
|
· Switch S8 defective
|
|
|
· MID defective
|
|
|
|
· Measure voltage between F2 and ground:
|
higher than 11 V
|
· Lead between starter switch S1 and F2
is interrupted
|
|
|
|
· Ignition OFF; remove instrument
assembly
|
|
|
· Release and disconnect 26-pin MID
wiring harness plug
|
|
|
· Ignition ON
|
|
|
· Measure voltage between 26-pin MID
wiring harness plug Ter. 16 and ground:
|
higher than 11 V
|
· Lead between F2 and 26-pin MID wiring
harness plug Ter. 16 is interrupted
|
|
|
· MID defective
|
|
|
|
|
|
If nominal
values are attained:
|
|
|
· MID defective
|
|
|
|
|
|
|
|
|
|
|