Remove
Headlamp – see operation "Headlamp, Remove and Install" or
"Headlamp with Xenon Dipped Beams, Remove and Install". For
headlamps with xenon dipped beams, unscrew bulb protective cap
– remove 3 screws or bulb protective cap.
I
|
Release servo motor by 1/4 turning and remove from headlamp.
Analogous procedure for right servo motor.
|
Install
II
|
Install servo motor in headlamp, during this slightly
counterhold reflector. Tighten servo motor. Bulb protective cap,
headlamps.
|
Check headlamp adjustment, correct if necessary.
|
|