Speedometer – Tachometer, Replace (up to
Model Year '97)
Remove
Remove instrument assembly – see operation "Instrument
Assembly, Remove and Install". 6 screws (arrows) from rear.
Caution
Do not remove Torx screws designated 1. Risk of destruction.
|
|
Remove
Lever off carefully central connection of temperature gauge and
fuel gauge using 2 screwdrivers, size 2-3 (section 2 pos. 1), until
central contact pin (section 2, arrow) is released.
|
|
Remove
Release 6 clips (arrows) and remove instrument housing from
cover. Install protection cover on tachometer/speedometer unit.
Caution
Never move speedometer needle.
|
|
Remove
Remove 4 screws from front side, remove instruments carefully
from instrument housing.
Caution
Do not damage connections for tachometer and speedometer.
|
|
Remove
Carefully cut upper (1) and lower (2) light cable predetermined
break points of temperature gauge and fuel gauge using small
diagonal cutting pliers.
|
|
Break off carefully temperature gauge and fuel gauge from
tachometer/speedometer unit at predetermined break point.
|
|
Install
Install tachometer/speedometer unit, temperature gauge and fuel
gauge in instrument housing. 4 screws in front side. Remove
protection cover, install instrument housing in cover and fasten
with 6 screws (arrows).
Caution
Do not turn Torx screws designated 1. Risk of destruction.
|
|
Caution
Check all connections (arrows) from printed circuit board to
instrument for correct seat.
Install
Install instrument assembly.
|
|
|