|
No.
|
TECH 1 Display
|
Conditions for
Checking
|
Nominal Value
|
Trouble Codes
|
Terminal
|
|
|
24
|
D.MIRROR H.MOTOR
|
Ignition ON
Set driver's/ co-driver's outside mirror switch to driver
|
|
18
|
13,
21
26-pin
plug
|
|
|
|
|
Outside mirror vertical/ horizontal rocker switch not
actuated
|
INACTIVE
|
|
|
|
|
|
|
Actuate outside mirror vertical/ horizontal rocker switch
until the parameter D.MIRROR H.MOTOR
indicates high percentage values and the motor has moved to the relevant end
stop.
Press one personal key and hold down
While the mirror moves to the stored position
|
RIGHT
|
|
|
|
|
|
|
Actuate outside mirror vertical/ horizontal rocker switch
until the parameter D.MIRROR H.MOTOR
indicates low percentage values and the motor has moved to the relevant end
stop.
Press one personal key and hold down
While the mirror moves to the stored position
|
LEFT
|
|
|
|
|
|
|
|
|
|
|
|
|
Notes on Trouble-shooting:
|
Nominal Value:
|
Cause of fault:
(If nominal value is not
attained)
|
|
If outside mirror adjustment is not possible
· Eliminate fault in driver's outside
mirror circuit according to section 5.5. Then proceed with the following
trouble-shooting if necessary
|
|
|
|
|
· Separate wiring harness connection X11,
body/ driver's door (bayonet catch)
· Ignition ON
· Carry out F5:ACTUATOR TEST, test step 3
· During the check, measure voltage in
wiring harness coupling X11 between Ter. 20 and Ter. 19 with
multimeter
|
higher than 10 V
|
· Interruption between X11 and 26-pin
wiring harness plug for control unit
|
|
|
· Ignition OFF
· Remove mirror adjustment switch S68
from driver's door handle
· Release 9-pin wiring harness connection
for mirror adjustment switch and separate
· Set outside mirror switch for driver/
co-driver to driver
|
|
|
|
|
· Using multimeter, measure resistance in
9-pin wiring harness coupling
|
|
|
|
|
between
Ter. 9 and Ter. 5, pressing outside mirror horizontal/ vertical
rocker switch to the right
|
lower than 2 W
|
· Lead interruption or mirror adjustment
switch S68 defective
|
|
|
between
Ter. 9 and Ter. 6, pressing outside mirror horizontal/ vertical
rocker switch to the left
|
lower than 2 W
|
· Lead interruption or mirror adjustment
switch S68 defective
|
|
|
· Install mirror adjustment switch again.
|
|
|
|
|
· Ignition OFF, disconnect battery
negative terminal
· Remove driver's seat
· Release 26-pin wiring harness plug from
control unit and separate
· Using multimeter, measure resistance in
26-pin wiring harness plug between Ter. 21 and Ter. 13
|
50 W -
80 W
|
· Interruption in driver's door wiring
harness between wiring harness plug X11 and motor M30.1 for driver's outside
mirror
|
|
|
Further possible faults:
|
|
· Motor M30.1 for driver's outside mirror
defective
· Control unit K103 defective
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
