vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Other Information > < F5: ACTUATOR TEST - No. 06 INSIDE MIR. V.

Omega B

Electronically Controlled Seat / Mirror Adjustment with Memory   System Modification F7: PROGRAMMING

 

If a new control unit is installed in a vehicle or a control unit from one vehicle is installed in another vehicle, the control unit must be reprogrammed (the final stops of the seat motors or the values to avoid the submarine effect - seat cushion inclined forward - must be programmed).

 

Conditions for Checking

Nominal Value

Affected Terminals: -

Possible Trouble Codes: -

 

Important:

Before starting programming, always remove the folded - down cover from the fuse box (position of diagnostic plug); otherwise it will be damaged when the seat moves forward during programming.

 

Ignition ON

 

Close all doors except the driver's door

 

Safety measures:

The mechanic must position himself beside the driver's seat, outside the vehicle.

Under no circumstances may he sit in the driver's seat or any other seat in the vehicle interior.

 

In addition, no other persons must occupy the vehicle interior.

Danger, risk of injury

During programming, the motor end stops are not checked.

The programming procedure can be aborted at any time by pressing the TECH 1 EXIT key or by releasing the "M" seat memory switch.

 

Press key F7 in the main menu. Follow the instructions in the TECH 1 display.

 

Driver's door open

 

The manual adjustment switches for the seat and mirrors must not be pressed.

 

The memory switch and the three position switches must not be pressed.

 

 

Once the display on the right has been answered with YES, press the memory switch and hold it down until

the programming procedure is completed. If the memory switch is released during the programming procedure, the programming procedure may be aborted as incomplete, or incorrect end stops may be programmed.

 

Note:

During the programming procedure, each seat motor is driven consecutively to its end stops and the determined potentiometer values are then stored in the control unit.

 

STAY OUT OF CAR FOR SEAT END POSITIONS PROG.

 

If the display on the right appears after programming is completed, programming was successful.

 

If not, a fault has occurred during programming. The following measures should be performed consecutively.

·     Read out trouble code;

·     Carry out Quick Check F0: DATA LIST;

·     Carry out Quick Check F5: ACTUATOR TEST;

·     Repeat programming;

·     Carry out TECH 1 self - test;

·     Check TECH 1 cable for damaged insulation and shielding;

·   Repeat programming with new control unit;

 

PROGRAMMING SEAT

END POSITIONS COMPLETED!

 

 

 

Other Information > < F5: ACTUATOR TEST - No. 06 INSIDE MIR. V.