Fuel Filler Flap, Remove and Install or Replace (Models F35, F19, F68)
Remove, Disconnect Closure cap (1), fuel filler flap. When replacing: Heat label with hot air drier, detach and use again.
Assemble Attach seal ring (2) from fuel filler flap. Detach seal ring all around in stages (3) and apply 1-component cyanoacrylate adhesive to guide (4). |
|
Assemble Observe instructions for use of adhesive. Do not apply adhesive to visible points. Attach sticker with adhesive.
Install, Connect Fuel filler flap, closure cap. Notice: Stickers with data on tyre pressures are available from Aftersales. |
|
|