Protective trim strips (Example: Model F19) Lever out side turn signal lamp (1), disconnect plug connection. Heat with hot air drier (max. 80 ° C). Remove protective trim strip uniformly to avoid denting outer door panel. Remove residual adhesive (washing benzene, silicone remover).
 Install, Connect Pull off protective strips from adhesive area. Insert positioning clips for protective trim strip (2) into drilled holes of front/ rear door. Press in protective trim strip. Plug connection, side turn signal lamp.
 Important! Surface must be dry and free from dust and grease. Heat protective trim strips in area of adhesive tape. Final drying, e.g. in winter, with radiator max. 60 ° C/140 ° F, safe distance approx. 40 cm/15 in. to object. | 
Remove, Disconnect 
