C-05, Airbag Passenger Circuit |
Test |
Work Order Description |
Nominal Value |
T01 |
Check: Short Circuit in Wiring Harness |
|
|
• Ignition OFF • Disconnect wiring harness connector from: X93 Control Unit - Airbag & Airbag Unit - Codriver 2P • Ignition ON • Diagnostic Tester Data List Parameter PASS. SQUIB RES. |
greater than 6 Ohm |
|
Yes: T02 |
No: E05 |
T02 |
Check: Interruption in Wiring Harness |
|
|
• Connect fused jumper wire to: X93 Control Unit - Airbag & Airbag Unit - Codriver 2P Wiring Harness Connector (wiring harness side) Terminal 2 & X93 Control Unit - Airbag & Airbag Unit - Codriver 2P Wiring Harness Connector (wiring harness side) Terminal 1 • Diagnostic Tester Data List Parameter PASS. SQUIB RES. |
less than 1 Ohm |
|
Yes: T03 |
No: E04 |
T03 |
Check: Short to Voltage/Ground of Signal Circuit |
|
|
• Measure voltage between the following terminals: X93 Control Unit - Airbag & Airbag Unit - Codriver 2P Wiring Harness Connector (wiring harness side) Terminal 1, 2 & Ground Note: Do not remove fused jumper wire |
0.5 ... 2.5 V |
|
Yes: E01 |
No: T04 |
T04 |
Check: Short to Voltage/Ground of Signal Circuit |
|
|
• Measure voltage between the following terminals: X93 Control Unit - Airbag & Airbag Unit - Codriver 2P Wiring Harness Connector (wiring harness side) Terminal 1, 2 & Ground Note: Do not remove fused jumper wire |
less than 0.5 V |
|
Yes: E02 |
No: E03 |