Place contact unit with both guide pins (1) at signal switch housing and press on uniformly and parallel (I) until 4 clips (2) catch. Contact unit must not be attached tilted (II). Check correct seating of clips. Clips must not be damaged. Attach wiring harness plug (3) to bushing (4) of contact unit and without using force pull wiring harness plug onto the bushing by pressing in the slider (5). Install signal switch panelling. For vehicles with right-hand drive: adjust airbag contact unit using KM-988 - see operation "Steering Wheel, Remove and Install (Vehicles with Airbag as of MY '98)" in group "M". Align steering wheel if necessary with KM-989 and install - see operation "Steering Wheel, Remove and Install" in group "M". |