Seat Belt - Front, Remove and Install
 Remove, Disconnect Seat panelling cover, seat belt from seat (1), B-pillar inner panelling, open shackle (2), upper seat belt (3), outer B-pillar cover, reel retractor. Notice: To remove the reel retractor, use deep (80 mm/ 3.15 in.) (spanner size 16 mm).
Remove, Disconnect Separate bolt from seat belt, thread seat belt through inner panelling of B-pillar. | 
|
 Install, Connect Thread seat belt through upper B-pillar inner panelling. Close shackle, reel retractor, B-pillar outer cover, bolt, seat belt at top, seat belt to seat, seat panelling cover, B-pillar inner panelling.
 Tighten (Torque) Inertia reel retractor to B-pillar - 35 Nm / 26 lbf. ft. Seat belt to seat - 20 Nm / 15 lbf. ft. B-pillar seatbelt - 35 Nm / 26 lbf. ft.
|
