ECC Controls, Remove and Install
 Remove, Disconnect Remove ECC controls panel - see corresponding operation. Remove radio and radio installation frame - see operation "Radio Installation Frame, Remove and Install" in group "R". Remove all control switches and switch strip - see operation "Switch Strip, Remove and Install" in group "N". Release wiring harness plugs (1, 2) and remove from ECC controls. For vehicles with full cover: Remove fastening screws (3, 4). Push in two lugs at bottom (II, arrows) with screwdriver, push ECC controls forwards and remove upwards.
 Important! The control electronics within the ECC controls assembly can be replaced separately. The cover is used as transportation protection and must be replaced with the previous cover prior to installation. Observe information on control unit label. | 
|
 Install, Connect Insert ECC controls, at the same time note the position of the guide pins (III, arrows). Connect wiring harness plug and lock. For vehicles with full panel: screw on ECC controls with bolts (3, 4). Install switch strip and actuating switch. Install radio installation frame and radio - see operation "Radio Installation Frame and Radio, Remove and Install" in group "R". Install ECC controls panel - see corresponding operation..
 Adjust Synchronise the servomotors after replacing controls: Ignition ON, push AUTO and OFF buttons simultaneously for approx. 5 seconds. |
|
|
