If there is noticeable play on an installed wheel, measure as follows: Disconnect rear wheel. In version with drum brake: disconnect brake drum - see operation "Brake Drum, Remove and Install" in group "H". Screw KM-468-A (1) to brake disc or to wheel bearing unit. Install Gauge MKM-571-B (2) with gauge holder and magnetic foot (3) to traverse control arm or cover plate. Position probe of gauge at lower edge of brake disc or wheel bearing unit. Check play by levering slightly with KM-468-A. Max. permissible tilt play = 0.3 mm. The wheel bearing unit must be replaced if this value is exceeded - see operation "Wheel Bearing Unit, Remove and Install". |