Vauxhall Workshop Service and Repair Manuals

Charge Pressure Sensor, Remove and Install  

Notice: 

F 9881 shows X 20 DTL.  

  Remove, Disconnect   

Remove engine cover.   Detach wiring trough (1) from cylinder head cover and from upper part of intake manifold and set aside to rear - disconnect necessary wiring harness plugs.   Detach charge pressure sensor (2) from upper part of intake manifold.     Install, Connect    Attach charge pressure sensor with new seal ring to upper part of intake manifold - tightening torque 8 Nm / 6 lbf. ft.   Attach wiring trough to cylinder head cover and upper part of intake manifold - re-connect detached wiring harness plug.   Install engine cover.