Vauxhall Workshop Service and Repair Manuals

DIS Ignition Module, Remove and Install  

  Remove, Disconnect   

Disconnect ignition cable plug (1) and wiring harness plug (3) from DIS ignition module (2) - mark installation position and detach DIS ignition module from bracket.     Install, Connect    Attach DIS ignition module (2) to bracket - tightening torque 8 Nm / 6 lbf. ft.   Connect wiring harness plug (3) to DIS ignition module.     Important!    Note ignition sequence - cylinder numbers are located on ignition cables as well as on the DIS ignition module itself.     Install, Connect    Connect ignition cable plug (1) to DIS ignition module.