Fuel escapes - collect escaping fuel in suitable container, observe safety regulations and national legislation.
Install, Connect Connect Fuel Pressure Gauge KM-J-34730-91 (2) to test connection (1). Start engine and bleed fuel gauge - idle speed. Collect escaping fuel in a suitable container.
Inspect Start engine and allow to run at idle speed, nominal value: see relevant "Checking Procedures". Apply 0.5 bar to fuel pressure regulator using Vacuum Pump MKM-667, nominal value: see relevant "Checking Procedure".
Remove, Disconnect Disconnect Fuel Pressure Checking Unit KM-J-34730-91 from checking connection. |