vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Immobiliser with Immobiliser Control Unit Transponder, Remove and Install Install > < Modification to Control Unit Housing Immobiliser with 90 degree ignition lock.

Vectra B

 

Immobiliser Control Unit, Remove and Install  

Object Number: 616201 Size: DEFAULT  Important!   

When the immobiliser control unit is replaced, it must be reprogrammed - see corresponding Checking Procedures.  

Object Number: 616191 Size: DEFAULT  Remove, Disconnect   

Remove fastening bolts (arrows) and remove signal switch panelling.  

Disconnect ignition key and ignition lock cover. Disconnect wiring harness plug from immobiliser control unit. Unclip immobiliser control unit from ignition lock housing and pull forwards.  

 

1  Immobiliser control unit  

2  Ignition lock panel  

3  Transponder key  

4  Transponder  

5  Lock cylinder  

6  Ignition lock housing  

 

Object Number: 2392692 Size: DEFAULT

 

 

Object Number: 616192 Size: DEFAULT  Install, Connect   

Slide immobiliser control unit onto ignition lock housing and clamp tightly.  

Connect wiring harness plug (2) to immobiliser control unit.  

Place on ignition lock cover (1).  

Install signal switch panelling (5 fastening bolts).  

Object Number: 2392693 Size: DEFAULT

Immobiliser with Immobiliser Control Unit Transponder, Remove and Install Install > < Modification to Control Unit Housing Immobiliser with 90 degree ignition lock.