volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 7682 > < Diagram Information and Instructions|Page 7680
Page 6
background image

The vacuum-controlled Central Locking System from current Golf/Jetta models has been replaced by electrically operated door locks. Each Door
Control Module signals the Central Control Module and the other Door Control Module by way of the CAN-bus when a door is locked or unlocked.

The block diagram shows an example of using the driver's door lock to lock the vehicle, close the windows and sunroof and set the anti-theft alarm.

The Door Control Module, Driver Side -J386- is activated by the Lock Module for Central Locking, Driver Side -F220- when the key is turned in the
lock cylinder.
-

-J386- checks status of -F220- to determine whether door is closed.

-

If closed, -F220- locks the driver's door.

The lock signal is sent over the CAN-bus to the Central Control Module for Comfort System -J393- and to the Door Control Module, Passenger Door
-J387-.
-

-J387- independently initiates the lock function in the passenger door

-

-J393- switches off the Interior Light, and activates the Anti-theft Alarm.

This sequence can be initiated by using the Radio-frequency Remote Control.

The Central Locking System can also be activated using the Switch for Interior Lock, Driver Side -E150- or the Switch for Interior Lock, Passenger
Side -E198-. If a door lock button is pressed, only the lock for that door is activated.

The Central Locking System can also be unlocked by the Airbag Control Module. In the event of a collision with enough force to deploy the airbag,
the Airbag Control Module -J234- also signals the Central Control Module for Comfort System -J393- to unlock the doors and switch on the interior
light.

Central Locking Radio-frequency Remote Control

All New Beetles come with remote control for the central locks. It is built into the Control Module for Comfort System, or the Central Locking System
Control Module for vehicles without power windows. The remote control has the following functions:
-

Selective door unlocking.

-

Locking of both doors.

-

Setting of the Anti-theft Alarm.

-

Rear lid opening.

-

"Panic" function.

Selective unlocking unlocks the driver's door with one press of the unlock button. A second press of the unlock button will unlock the passenger door.
If a door is not opened within 30 seconds of an unlock command being received by the Central Locking Control Module or Control Module for
Comfort System, the doors will lock again.

The Anti-theft Alarm is set when the doors are locked. Confirmation is by a short sounding of the Anti-theft Warning Horn and a brief flash of the
emergency flashers.

Pressing the rear lid button will unlatch the lid electrically.

Diagram Information and Instructions|Page 7682 > < Diagram Information and Instructions|Page 7680