Beetle L4-1781cc 1.8L Turbo (APH) (1999)
-
Ignition switched off.
Test sequence
-
Remove driver-side storage compartment.
-
Disconnect connector from Clutch Vacuum Vent Valve Switch -F36-.
Vehicles with 2-pin clutch vacuum vent valve switch
-
Measure resistance between terminals 1 + 2 of switch.
Specified value
Clutch pedal not depressed: max. 1.5 Ohms
Clutch pedal depressed: Infinite Ohms
Vehicles with 4-pin clutch vacuum vent valve switch
-
Measure resistance between terminals 2+3 of switch.
Specified value
Clutch pedal not depressed: max. 1.5 ohms
Clutch pedal depressed: Infinite Ohms
Continuation for all vehicles
If specified values are not obtained:
-
Replace Clutch Vacuum Vent Valve Switch -F36-.
NOTE: Note installation position of clutch vacuum vent valve switch in the upper installation bore of mounting bracket.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/Read Measuring Value Blocks (Function 08)/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified values are obtained:
Vehicles with 2-pin clutch vacuum vent valve switch