Beetle L4-1781cc 1.8L Turbo (APH) (1999)
/Page-938004.png)
Display Group 36
If the specification is attained:
-
Press -> key.
-
Press keys 0 and 6 for the function "End output" and confirm entry with the Q key.
-
Switch off ignition.
Continuation
If the specification is not attained:
-
Press -> key.
-
Press keys 0 and 6 for the function "End output" and confirm entry with the Q key.
-
Carry out a test drive to remove possible residue on oxygen sensor and repeat check.
Observe the valid safety precautions when carrying out a road test.
If the specifications are again not attained:
-
Replace the oxygen sensor after catalyst (G130), item 11.
-
Check DTC memory, if necessary, repair any malfunctions and then erase DTC memory. Checking and erasing DTC memory. Refer to
"Displaying, Reading and Erasing Trouble Codes/With Manufacturers Scan Tool/DTC Memory, Checking And Erasing", See: Testing and
Inspection
-
Read-out the readiness code. If the DTC memory has been erased or the engine control module was disconnected from permanent positive, the
readiness code must be generated again.
Refer to "Monitors Trips and/or Drive Cycle/Displaying Readiness Code", See: Testing and Inspection
Refer to "Monitors Trips and/or Drive Cycle/Generating Readiness Code", See: Testing and Inspection
Evaluating display group 36, display zone 1 - oxygen sensor voltage oxygen sensor after catalyst
