Beetle L4-2.0L (AEG) (2000)
/Page-1788003.png)
-
Verify both CD changer position settings. Settings must be located on top.
If not, loosen lateral screws, slide them toward top into "V" position and tighten.
-
Tightening torque: 3 Nm (27 in lb)
NOTE:
-
CD playback will skip if switches are not set correctly.
-
Always check/set switches prior to CD installation.
-
Switches must move completely to their end positions.
-
Attach support -1- to CD, install with screws -2-.
-
Tightening torque: 3 Nm (27 in lb)
-
Connect CD Changer harness cable connector (arrow).
-
Place connectors -1- in bracket and CD Changer in bracket.
