Beetle L4-2.0L (AEG) (2000)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor on Rear Axle (Drum Brakes)
Wheel Speed Sensor On Rear Axle (Drum Brakes), Removing And Installing
Removing
-
Raise vehicle.
-
Disconnect wheel speed sensor and speed sensor wiring connector -1-,
-
Remove bolt -2- from stub axle.
-
Pull ABS wheel speed sensor out of stub axle.
Installing
-
Before inserting speed sensor, clean hole inner surface and coat speed sensor with grease, Part No. G 000 650.
-
Insert speed sensor into hole in stub axle and tighten bolt to 8 Nm (71 inch lbs.).
-
Connect speed sensor to speed sensor wiring.
ABS Wheel Speed Sensor Wiring To Rear Axle, Removing And Installing
Required Special Tools
^
VAS 1978 wiring harness repair kit
Removing
-
Obtain radio code on vehicles with coded radio.
-
Disconnect battery.
-
Disconnect wheel speed sensor and speed sensor wiring connector
-
Remove rear interior side panel, Refer to Body and Frame.
-
Strip insulation (arrow) from shrink connection.