Beetle L4-2.0L (AEG) (2000)
-
Press in seal with press sleeve from 3266, using old center bolt for crankshaft toothed belt sprocket:
-
Press in sleeve up to stop.
Only PTFE oil seals
-
Install guide sleeve T10053/1 onto crankshaft journal.
-
Slide oil seal over guide sleeve onto crankshaft stub.
-
Press in oil seal onto stop using press sleeve T10053 and bolt T10053/2 (M16 x 1 5 x 60).
Continued for all oil seals
-
Install crankshaft toothed belt sprocket and hold with 3415 counterhold.
-
Tighten central bolt.
Tightening torque: 90 Nm (66 ft. lbs.) plus additional 1/4 turn (90°) further (turning further can be done in several stages)
Note: Thread and shoulder must be free of oil and grease.