Beetle L4-2.0L (AEG) (2000)
-
Check wiring for open circuit between Test Box and connector using Wiring diagram.
-
Terminal 1 + socket 74
-
Terminal 2 + socket 67
-
Terminal 4 + socket 75
-
Terminal 5 + socket 62
-
Terminal 6 + socket 69
-
Terminal 7 + socket 59
-
Terminal 8 + socket 66
-
Resistance 1.5 Ohms maximum
-
Check wires for shorting to one another.
-
Specification: Infinity Ohms
If wiring is OK:
-
Check Engine Control Module Voltage supply. Refer to "Control Module Voltage Supply Check", See: Engine Control Module/Testing and
Inspection
-
Display the Readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
-
If DTC memory was erased or if the ECM was disconnected from Battery + , set the Readiness code. See: Testing and Inspection/Monitors, Trips,
Drive Cycles and Readiness Codes