Beetle L4-2.0L (AEG) (2000)
Rapid data transfer
HELP
Select function XX
-
Press 0 and 6 buttons to select "End output" function 06.
-
Press Q button to enter input.
-
Switch OFF ignition.
-
Check Voltage supply of Throttle Control Module and wiring to Control Module.
If Voltage supply and wiring OK:
-
Replace Engine Control Module.
Check continuation when display is above 90 angle degree
-
Disconnect harness connector -1- from Throttle Control Module -2-.
If display is 0 angle degree:
-
Press -> button.
-
Press 0 and 6 buttons to select "End output" function 06.
-
Press Q button to enter input.
-
Switch OFF ignition.
-
Replace Throttle Control Module J338.
-
Match Engine Control Module to Throttle Control Module.
When display is above 90 angle degree:
-
Press -> button.
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press 0 and 6 buttons to select "End output" function 06.
-
Press Q button to enter input.
-
Switch OFF ignition.
-
Check Throttle Control Module Voltage supply and wiring to Control Module.
If Voltage supply and wiring OK:
-
Replace Engine Control Module.
Throttle Control Module Voltage supply and wiring, checking