Beetle L4-2.0L (AEG) (2000)
WARNING!
-
Refer to Warnings and Safety Measures
-
Dispose of electrolyte (sulfuric acid/water mixture) properly! Waste electrolyte must only be disposed of in appropriate waste disposal
sites. Refer to local regulations pertaining to electrolyte disposal.
-
DO NOT load test batteries which are gassing. Otherwise there is a risk of explosion.
-
The following notes and procedures must be followed to ensure correct measurements.
NOTE:
-
In order to better determine a battery's overall condition, it is recommended to always perform the load test in conjunction with the electrolyte
specific gravity test. See: Specific Gravity
-
It is not necessary to remove battery from vehicle or disconnect battery terminals.
Special tools, testers and auxiliary items needed
-
Battery tester VAS 1979, VAS 5033, Christie Automotive BT-9000 or equivalent
-
Switch ignition off
-
Connect tester leads to battery posts as described in the tester instruction manual. Tester leads must be securely fastened and make proper contact
with the battery posts.
-
Load current and minimum voltage specifications vary depending on battery capacity. Apply load as per tester instructions, or for 5 seconds at
load specified.
If the minimum voltage specification is not reached, replace battery.
Load test results