Cabrio GLX L4-2.0L (ABA) (2001)
Electronic Throttle Control Module: Testing and Inspection
Throttle Valve Potentiometer, Checking
Checking Throttle Valve Potentiometer
Test sequence
-
Connect VAG 1551 Scan Tool ((VAG 1552). Then switch ignition on and select engine control module with the "Address word" 01. (Connecting
scan tool and selecting engine control module See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool
Connecting/With Manufacturer's Scan Tool/Connecting VAG Scan Tool 1551/1552).
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press keys 0 and 8 for function "Read Measuring Value Block" and confirm entry with Q key.
Indicated on display
Read Measuring Value Block
HELP
Input display group number XXX
-
Press keys 0, 5 and 4 for "Display group number 54" and confirm entry with Q key.
Indicated on display: (1 to 4 Display zones)
Read Measuring Value Block 54
->
1
2
3
4
-
Read off throttle valve angle in display zone 3.
Throttle valve in start position: 0 to 6 angle degree
-
Slowly open throttle valve slowly until fully open and observe angle display in display zone 3. Figure must increase uniformly overcomplete range
up to a: min. 75.
-
Press -> key.
-
Press keys 0 and 6 for "End data transfer" function and confirm input with Q key.
-
Switch ignition off.
NOTE: The displayed figure is dependent on the tolerances of the throttle valve potentiometer and does not correspond to the actual opening angle.
If the figure does not increase uniformly:
-
Replace throttle valve control module -J338-.
If the display constantly shows 0 angle degree or is above 90 angle degrees:
Display
Cause
0 angle degree
Open circuit or short to positive
above 90 angle degree
Short to Ground
Continuation of check when display 0 angle degree:
-
Pull 8 pin connector off throttle valve control module.
-
Bridge connector contacts 5+7 with auxiliary cables from VAG 1594 and observe display.