Cabrio GLX L4-2.0L (ABA) (2001)
Fig. 1 Circlip, removing and installing
-
Press piston cap with intermediate spring ring down far enough for circlip (arrow) to be inserted in groove.
Fig. 2 Thrust plate and plates, installing on inner plate carrier
-
Install thrust plate -a- with smooth side facing inner plate and stepped side toward inner plate carrier.
-
Install 3 inner plates -b- and 2 outer plates -c-.
-
Clip in supporting ring with step (arrow).
Note:
^
Position locating lugs correctly.
^
Corrugated washer, inner and outer plates, installing in clutch housing refer to Fig. 3.
Fig. 3 Corrugated washer, inner and outer plates, installing in clutch housing
-
First insert corrugated washer.
-
Insert 2 mm thick outer plate.
-
Insert remaining inner and outer plates.
Fig.4 Inner plate carrier and circlip (arrow), installing.
-
Lift inner plate carrier slightly to install circlip (arrows).
3rd and 4th Gear Clutch -K3- With Turbine Shaft