Cabrio GLX L4-2.0L (ABA) (2001)
Fluid Pump: Service and Repair
Replacement ATF pump parts and the ATF pump must comply with transmission code.
1. Piston ring
^
Check that it is correctly located refer to Fig. 1
^
Fitting refer to Fig. 2
2. Piston ring
^
Check that it is correctly located refer to Fig. 1
^
Fitting refer to Fig. 2
3. Piston ring
^
Check that it is correctly located refer to Fig. 1
^
Fitting refer to Fig. 2
4. Thrust washer
5. Piston
^
Seals are vulcanized to the piston
^
Moisten seals with ATF before inserting
^
Turn piston slightly when installing
6. Bolt
^
10 Nm (89 inch lbs.)
^
Then turn 45° further
7. Stator support
8. Outer gear
^
Manufacturer's mark (arrow) faces stator support
^
If outer gear is incorrectly installed ATF pump may not operate freely in installed position
9. Inner gear
^
Larger groove faces stator support
10. Housing for ATF pump
11. O-ring
^
Always replace
12. Torque converter oil seal
^
Removing and installing. Refer to Torque Converter; Torque Converter Seal.