Cabrio GLX L4-2.0L (ABA) (2001)
/Page-1117001.png)
Axle Shaft: Service and Repair
Axle Shafts, Removing and Installing
Special tools and equipment
^
3283 Press tool
^
VAG 1756 Angle wrench
^
VW 408A Press tool
^
VW 402 Press plate
^
VW 401 Press plate
^
VW 522 Support sleeve
^
40-204A Tensioner
Removing
Ensure wheel bearings are not loaded with 12-point nuts loose.
If bearings are loaded by vehicles weight and 12-point nuts are loose wheel bearings will be stressed and their life expectancy reduced.
If a vehicle is moved after removing axle shaft, first install outer joint and tighten to 50 Nm (37 ft 11b).
-
Lift vehicle to relieve load on front axle.
-
Loosen 1 2-point nut.
-
Disconnect axle shaft from transmission drive flange.
-
Mark bolt installation position.
-
Remove bolts -1-.
