Cabrio GLX L4-2.0L (ABA) (2001)
/Page-1118003.png)
^
Use VW 161 a to remove and install
12-Axle shaft, left (solid shaft)
13-Clamp
^
Tensioning refer to Fig. 9
^
Always replace
14-Protective boot
^
Check for punctures and chafing
^
Material: Hytrel (Polyelastomer)
15-Hose clip
^
Tensioning with pliers VAG 1682 refer to Fig. 8
^
Always replace
16-Spring washer
^
Installation position refer to Fig. 4
17-Bolt
^
35 Nm (26 ft lb)
18-Heat shield
19-Thrust washer
^
Installation position refer to Fig. 4
20-Circlip
^
Insert in shaft groove
^
Always replace
21-Outer CV joint
^
Only replace complete
^
Removing refer to Fig. 1
^
Installing: drive on shaft to stop with plastic hammer
^
Greasing
^
Checking refer to Testing and Inspection
Fig. 1 Outer CV joint, removing
-
Drive joint off axle shaft with firm blow from aluminium hammer.
Fig. 2 Inner CV joint, pressing off
Note:
^
Support ball hub while pressing off
^
Use drift to remove boot
