Cabriolet L4-1781cc 1.8L SOHC (JH) (1989)
-
install threaded plug, from kit (arrow 1) using a new seal
-
install cap nut, from kit, onto fuel return line banjo bolt (arrow 2)
Note
The following steps require a second technician to ensure that they are performed without pause. Any delay in starting after attaching the aerosol can
could cause flooding and a no-start condition.
-
thread aerosol container, P/N: G-001600, into fitting on (supply side) adapter line
-
HAND TIGHTEN ONLY
CAUTION
When performing step 3, safety glasses MUST be worn.
CAUTION
FLAMMABLE MATERIAL. Hold aerosol container upright, avoiding ALL electrical contact.
CORROSIVE MATERIAL. Do NOT allow to come in contact with painted surfaced or rubber hoses.
CAUTION
Part numbers are for reference only. Always check with your Parts Department for latest information.
CAUTION
When performing step 3, safety glasses MUST be worn.
-
IMMEDIATELY start engine and run at approximately 3000 rpm. Keep engine running until container is empty (approximately 5 minutes) even
though engine may run rough and try to stall