Cabriolet L4-1781cc 1.8L SOHC (JH) (1989)
Ignition Switch Lock Cylinder: Service and Repair
IGNITION LOCK CYLINDER, REMOVING/INSTALLING
WARNING: Special safety precautions apply to vehicles equipped with airbags.
Removing:
-
Remove steering lock housing. See: Ignition Lock/Service and Repair
-
Mark steering lock housing for hole at intersection of points a and b.
-
Dimension a = 12 mm (15/32 in.)
-
Dimension b = 10 mm (25/64 in.)
-
Drill 3 mm (1/8 in.) diameter hole into steering lock housing at mark until lock cylinder stop spring is visible.
Hole depth: approx. 3 mm (1/8 in.)
-
Compress stop spring using opposite end of drill and pull out lock cylinder.
Installing:
-
Insert lock cylinder into steering lock housing.
-
Insert key into lock cylinder.
-
Push lock cylinder fully into housing while gently turning key.