CC 4Motion (357) V6-3.6L (BLV) (2011)
Install two specialty plates (washers) Part No.:
7M3499349A following the procedure below.
Tip:
Part number(s) are for reference only. Always see ETKA for the latest part(s) information.
^
Loosen by two turns, the four bolts towards the rear of the sub frame. Remove one inboard bolt.
^
Insert washer Part No. 7M3499349A between sub frame and body, centered on the hole with tabs of washer pointing rear and down as shown.
^
Insert a new bolt and hand tighten.
^
Repeat the above procedure with second inboard bolt.
^
Tighten all 4 bolts, in accordance to Repair Manual Group 40 Front suspension, driveshaft in ElsaWeb
Note:
Sub frame bolts MUST be replaced after every removal.