Corrado L4-1781cc 1.8L SOHC SC (PG) (1990)
Hall Effect Sensor: Service and Repair
Hall Sensor, Replacing
Distributor View
NOTE: This procedure requires that the distributor is removed from the engine block. For distributor removal and installation procedure, refer to
IGNITION SYSTEM.
1.
Remove the distributor cap and rotor.
2.
With snap-ring pliers, remove the Shutter wheel snap ring.
Trigger Wheel Removal
3.
Use two screwdrivers positioned at opposite sides of the Shutter wheel as shown. Insert the screwdriver as far as possible to avoid any damage to
Shutter wheel.
4.
Pry the shutter wheel up and remove it from the shaft.
NOTE: Make sure you don't loose the small shutter wheel locating pin.
6.
Remove following washer and snap-ring.