Corrado L4-1781cc 1.8L SOHC SC (PG) (1990)
Shifter A/T: Service and Repair
SELECTOR LEVER
Disassembling and Assembling
Note:
Selector lever must be removed to replace individual parts.
1
- Selector lever
- Assembling - Fig. 1
2
- Indicator lighting
- Mounting indicator lighting connector - Fig. 4
3
- Spring
4
- Push rod
- Grease in area of sliding surfaces
5
- Guide sleeve
- Fit after installing push rod
6
- Set screw
- Always replace
- To remove, first remove Shift lock Solenoid and indicator lighting -2-. Clamp set screw in vice and loosen by turning selector lever
- Install with thread-locking fluid AMV 185 101 A1
7
- Shift lock Solenoid -N110-
- Adjusting - Fig. 2
- Functional check - Fig. 3
- Can be checked by On Board Diagnostic (OBD) program
8
- Screw
- Tightening torque: 3 Nm (27 in lb)
- Qty. 2