Corrado V6-2792cc 2.8L DOHC (1992)
-
Pull bumper 1 forward out of plastic retainers 14 (requires two mechanics).
-
Bolts 15 tightening torque = 2 Nm (18 in. lb).
-
Pry fasteners out of plastic clips with screwdriver.
-
remove support bracket from cover
Installing
Note: Install front bumper in reverse order of removal procedure, noting the following:
-
Press cover and bumper together.
-
Begin at center of bumper and push both parts together until all plastic clips snap into place.
-
Bolts 9 tightening torque = 85 Nm (63 ft lb).
-
When replacing bracket 6, attach it centered on support bracket in order to adhere to the gap dimension a = 8 mm (5/16 in.) between the bumper
cover and fender.
Gap dimension, fender to bumper
1 - fender
2 - bumper cover
a = 8 mm (5/16 In.)
