Corrado V6-2792cc 2.8L DOHC (1992)
- Lower headliner and pull forward slightly to pull rear tab (arrow) from roof reinforcement.
- Remove headliner through rear lid opening.
- Disconnect water drain hoses from sunroof assembly frame.
- Remove electric cable drive.
- Remove sunroof panel from above (for easier panel frame installation), See: Removing and Installing Sunroof Panel
- Remove hex head bolts and pull out assembly frame with help of an assistant.
Installing
- Install sunroof assembly frame and tighten hex head mounting bolts 7.5 Nm (6.0 ft lb).
- Install sunroof lid.
- Adjust electric cable drive to closed position, See: Adjustments
- Install electric cable drive.
- Install water drain hoses to sunroof assembly frame.
- Install one-piece molded headliner so that rear tabs engage roof reinforcement.
Note: If a functional test of the sunroof is to be performed without the headliner, first install the sunroof perimeter sealing bead, (see below).
- Install front header trim.
- Install rear header trim.
- Install A-pillar, B-pillar, and C-pillar trim.
- Install seat belt guides and height-adjuster knobs.
- Install clothes hook.
- Install grab handle.