Corrado V6-2792cc 2.8L DOHC (1992)
To determine closed position:
- Pivots 3 must be within the marked area (arrow) and locking levers 4 must be engaged in the guide rails.
If NO:
- Adjust sunroof panel to closed position as specified in Parallel Alignment, See: Adjustments
- Install slide/tilt sunroof panel from above and insert mounting screws for lever/panel.
- Position slot of adjusting washer 2 on locating pins 3 before tightening Torx screw 1.
- Lightly tighten mounting screws 1 (Torx).
- Adjust sunroof panel height, See: Adjustments
- Tighten mounting screws fully 6 Nm (4.5 ft lb).
- Install headliner frame onto guide rails.
