Corrado V6-2792cc 2.8L DOHC (1992)
BRAKE ROTOR REMOVING/INSTALLING
1. Remove grease cap.
2. Remove cotter pin and nut retainer.
3. Remove nut and thrust washer.
4. pull rotor off spindal.
5. Reverse proceedure to install adjusting bearing play (thrust washer must be movable using finger pressure against a screwdriver withoput prying.)
BRAKE PADS, INSTALLING
1. push piston into caliper housing
2. install brake pads and heat shield
3. swing brake caliper down and tighten bolts to 35 Mm (26 ft lb)
Note: The two self-locking bolts in the repair kit must always be installed.
NOTE:After installing new brake pads, depress brake pedal firmly several times while vehicle is stationary to permit piston and brake pads to
adjust to brake disc.
